Toyota Corolla (E210): Favorite settings

My Settings

Drivers are identified using devices such as electronic keys to store the vehicle settings for each. Then the information can be recalled the next time the vehicle is driven.

Authentication devices can be assigned in advance to drivers so that they can drive using their preferred settings.

Settings for 3 drivers can be stored in My Settings.

For information on authentication devices registration/ deletion, changing the driver's name, initializing driver registered settings, manually switching drivers and deleting drivers registration refer to the "MULTIMEDIA OWNER'S MANUAL".

Types of assigned authentication devices

An individual can be identified using the following authentication devices.

  • Electronic key (vehicles with smart system)

An individual is identified when the smart key system detects their electronic key.

  • Bluetooth device

An individual is identified when a Bluetooth device is connected to the audio system. For information on how to connect Bluetooth devices, refer to the "MULTIMEDIA OWNER'S MANUAL". When an individual is identified with an electronic key identifying using a Bluetooth device is not performed.

Recalled functions

When an individual is identified from an authentication device, settings for the following functions are recalled.

  • Meter displays and audio system information*

When an individual is identified, the display settings used when the engine switch was last turned off are recalled.

  • Vehicle settings that can be set using the audio system*

When an individual is identified, the vehicle settings used when the engine switch was last turned off are recalled.

*: Some settings are excluded

    Share this page:

    Other materials:

    Replacement
    Hint: components: 1. Precaution 2. Disconnect battery negative terminal 3. Remove parking brake hole cover sub–assy 4. Remove floor shift shift lever knob sub–assy (m/t transaxle) 5. Remove shifting hole cover sub–assy (m/t transaxle) 6. Remove console panel upper 7. Remove conso ...

    Installing the spare tire
    1 Remove any dirt or foreign matter from the wheel contact surface. If foreign matter is on the wheel contact surface, the wheel nuts may loosen while the vehicle is in motion, causing the tire to come off. 2 Install the tire and loosely tighten each wheel nut by hand by approximately the sa ...

    Circuit description
    The rear heated oxygen sensor is used to monitor oxygen concentration in the exhaust gas. For optimum catalytic converter operation, the air fuel mixture must be maintained near the ideal ”stoichiometric” ratio. The heated oxygen sensor output voltage changes suddenly in the vicinity of ...