Toyota Corolla (E120): On–vehicle inspection

1. Inspect w/receiver condenser assy

  1.  if a fin of the w/receiver condenser assy is dirty, clean it with water and dry it with compressor air.

Notice

: do not damage the fin of the w/receiver condenser assy.

  1.  if a fin of the w/receiver condenser assy is bent, make it straight using a screwdriver or pliers.

2. Inspect w/receiver condenser assy for leakage of refrigerant

  1.  using a halogen leak detector, check pipe joints for gas leakage.
  2.  if gas leakage is detected in a joint, check the torque of the joint.
    Share this page:

    Other materials:

    Tire pressure warning system (if equipped)
    Your vehicle is equipped with a tire pressure warning system that uses tire pressure warning valves and transmitters to detect low tire inflation pressure before serious problems arise. ◆ Installing tire pressure warning valves and transmitters When replacing tires or wheels, tire press ...

    Confirmation driving pattern
    Connect the hand–held tester or the obd ii scan tool to the dlc3.  record dtcs and the freeze frame data.  set the check mode using the hand–held tester .  read the value on the misfire counter for each cylinder when idling. If the value is displayed on the misfire c ...

    Steering wheel
    Adjustment procedure 1. Hold the steering wheel and push the lever down. 2. Adjust to the ideal position by moving the steering wheel horizontally and vertically. After adjustment, pull the lever up to secure the steering wheel. WARNING ■Caution while driving Do not adjust the steering wheel wh ...