Toyota Corolla (E120): Inspection procedure

Hint

: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using the hand–held tester.

1 Perform active test by hand–held tester(abs warning light)

  1. Check that ”on” and ”off” of the abs warning light can be shown on the combination meter by the hand–held tester.

2 Inspect combination meter assy(abs warning light)

2 Inspect combination meter assy(abs warning light)

  1. Disconnect the connector from the skid control ecu.
  2.  turn the ignition switch to on.
  3.  check the abs warning light.

    Ok: abs warning light goes on

3 Check harness and connector(wa circuit)

3 Check harness and connector(wa circuit)

  1. Check for short circuit in harness and connector of the between terminal wa of skid control ecu and combination meter

Check and replace brake actuator assy

Check and replace brake actuator assy

    Share this page:

    Other materials:

    Body rocker panel moulding lh
    Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove body rocker panel moulding lh Remove the 8 retainers.  using a screwdriver, remove the moulding. Hint: tape the screwdriver tip before use.  remove the 7 clips from the moulding. 2. Insta ...

    Tire pressure warning system (if equipped)
    Your vehicle is equipped with a tire pressure warning system that uses tire pressure warning valves and transmitters to detect low tire inflation pressure before serious problems arise. ◆ Installing tire pressure warning valves and transmitters When replacing tires or wheels, tire press ...

    If the shift lever cannot be shifted from P (except vehicles with a manual transmission)
    If the shift lever cannot be shifted with your foot on the brake pedal, there may be a problem with the shift lock system (a system to prevent accidental operation of the shift lever). Have the vehicle inspected by your Toyota dealer immediately. The following steps may be used as an emergency ...