Toyota Corolla (E120): Input shaft assy (c59)

Share this page:

Other materials:

Battery
Check the battery as follows. ■ Battery exterior Make sure that the battery terminals are not corroded and that there are no loose connections, cracks, or loose clamps. 1 Terminals 2 Hold-down clamp ■Before recharging When recharging, the battery produces hydrogen gas which is ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

Replacement
1. Remove engine under cover rh 2. Drain coolant 3. Remove fan and generator v belt 4. Remove generator assy Disconnect the wire clamp from the wire clip on the rectifire end frame.  remove the rubber cap and nut, and disconnect the alternator wire.  disconnect the ...