Toyota Corolla (E170): Connecting a Bluetooth® audio player

► Registering an additional device Select “Select Device” on the Bluetooth® audio control screen.

►Selecting a registered device Select “Select Device” on the Bluetooth® audio control screen.

■Reconnecting a Bluetooth® phone

If the system cannot connect due to poor signal strength with the engine switch in ACCESSORY or ON <IGNITION ON> mode, the system will automatically attempt to reconnect.

If the phone is turned off, the system will not attempt to reconnect. In this case, the connection must be made manually, or the phone must be reselected.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the instrument panel ...

    On–vehicle inspection
    1. Inspection throttle body idle speed control valve assy Notice: it is impossible to check the resister value and the operation of isc valve by itself, because the isc valve has an ic circuit inside it, which transforms the duty signal from the ecm to the derive signal. After check ...

    Turn signal lever
    Operating instructions 1 Right turn 2 Lane change to the right (move the lever partway and release it) The right hand signals will flash 3 times. 3 Lane change to the left (move the lever partway and release it) The left hand signals will flash 3 times. 4 Left turn ■Turn signals can b ...