Toyota Corolla (E170): Displaying a Bluetooth® device details

You can confirm and change the registered device details.

Share this page:

Other materials:

Inspection procedure
1 Reconfirm dtc Check the dtc 2 Inspect skid control ecu connector securely connected 3 Inspect skid control ecu connector(ig1 terminal voltage) In case of using hand–held tester:  check the voltage condition output from the ecu displayed on the hand–held tester. O ...

Inspection procedure
1 Check hazard warning signal switch assy Check the hazard warning switch continuity, as shown in the illustration and table. Standard: 2 Check turn signal flasher assy 3 Check wire harness (tvip ecu turn signal flasher) Disconnect the tvip ecu and turn signal flashe ...

Circuit description
1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...