Toyota Corolla (E210): For safe driving

For safe driving, adjust the seat and mirror to an appropriate position before driving.

Correct driving posture

  1. Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer.
  2. Adjust the seat so that you can depress the pedals fully and so that your arms bend slightly at the elbow when gripping the steering wheel.
  3. Lock the head restraint in place with the center of the head restraint closest to the top of your ears.
  4. Wear the seat belt correctly.

WARNING

■For safe driving

Observe the following precautions.

Failure to do so may result in death or serious injury.

  • Do not adjust the position of the driver's seat while driving.

    Doing so could cause the driver to lose control of the vehicle.

  • Do not place a cushion between the driver or passenger and the seatback.

    A cushion may prevent correct posture from being achieved, and reduce the effectiveness of the seat belt and head restraint.

  • Do not place anything under the front seats.

    Objects placed under the front seats may become jammed in the seat tracks and stop the seat from locking in place. This may lead to an accident and the adjustment mechanism may also be damaged.

  • Always observe the legal speed limit when driving on public roads.
  • When driving over long distances, take regular breaks before you start to feel tired.

    Also, if you feel tired or sleepy while driving, do not force yourself to continue driving and take a break immediately.

  • Take care when adjusting the seat position to ensure that other passengers are not injured by the moving seat.
  • When adjusting the seat position, do not put your hands under the seat or near the moving parts to avoid injury. Fingers or hands may become jammed in the seat mechanism.

Correct use of the seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle.

Use a child restraint system appropriate for the child until the child becomes large enough to properly wear the vehicle's seat belt.

Adjusting the mirrors

Make sure that you can see backward clearly by adjusting the inside and outside rear view mirrors properly.

    Share this page:

    Other materials:

    Circuit description
    Shifting from 1st to o/d is performed in combination with on and off of the shift solenoid valve s1 and s2 controlled by ecm. If an open or short circuit occurs in either of the solenoid valves, the ecm controls the remaining normal solenoid valve to allow the vehicle to be operated smoothly ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

    Malfunction in fuel receiver gauge
    Wiring diagram Inspection procedere 1 Inspect fuel sender gage assy Disconnect the connector fuel sender gauge. check the float position between e and f and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously. S ...