Toyota Corolla (E120): Clutch pedal sub–assy (mtm)

Share this page:

Other materials:

Inspection procedure
1 Check side squib(lh) circuit(airbag sensor assy center – front seat airbag assy lh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the front seat airbag assy ...

On–vehicle inspection
1. Check battery electrolyte level Check the electrolyte quantity of each cell (maintenance–free battery).  If under the lower level, replace the battery (or add distilled water if possible) and check the charging system.  check the electrolyte quantity of each cell ...

Electronic control
Removal and installation of battery terminal  before performing electrical work, disconnect the battery negative (–) terminal cable beforehand so as to prevent burnt–out damage by short.  When disconnecting and installing the terminal cable, turn the ignition switch an ...