Toyota Tacoma manuals

Toyota Corolla Repair Manual: Circuit description

When the shift position is put in except d position, a signal is sent from the park/neutral position switch to the cruise control ecu assy. When this signal is input during cruise control driving, the ecu cancels the cruise control.

Wiring diagram

Inspection procedure

Park/neutral position switch circuit
...

Inspection procedure
1 Check operation(starter) Check that the starter operates normally and that the engine starts. 2 Input signal check See input signal check on page 05–745.  check the indicat ...

Other materials:

On–vehicle inspection
1. Inspect speedometer  check the operation. Using a speedometer tester, inspect the speedometer fro allowable indication error and check the operation of the odometer. Reference: Notice: tire wear and tire over or under inflation will increase the indication error. ...

Starting system
Inspection 1. Inspect starter assy Notice: these tests must be performed within 3 to 5 seconds to prevent burnout of the coil.  perform the pull–in test.  Remove the nut, then disconnect the lead wire from terminal c. Connect the battery to the starter repair ...

Trunk lid
General information To avoid locking the vehicle key in the vehicle, do not place the vehicle key in the cargo area. Depending on the vehicle equipment and country version, it is also possible to have the doors unlocked. To perform settings. The trunk lid cannot be opened if it is locked using th ...

© 2011-2023 Copyright www.tcorolla.net