Toyota Corolla (E120): Circuit description
The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh).
It causes the srs to deploy when the srs deployment conditions are satisfied.
Dtc b0118/46 is recorded when a b+ short is detected in the side squib (lh) circuit.
Wiring diagram
Other materials:
Follow the correction procedures. (vehicles with a smart key system and with
a drive monitor display)
After taking the specified steps to correct the suspected problem, check that
the warning light turns off.
■SRS warning light
This warning light system monitors the airbag sensor assembly, front impact
sensors, side impact sensors (front door), side impact sensors (front), side impac ...
Selecting tire chains
Use the correct tire chain size when mounting the tire chains.
Chain size is regulated for each
tire size.
Side chain (0.12 in. [3 mm] in
diameter)
Side chain (0.39 in. [10 mm]
in width)
Side chain (1.18 in. [30 mm]
in length)
Cross chain (0.16 in. [4 mm]
in diameter)
Cross chain (0.55 i ...
Replacement
1. Remove combination meter assembly
2. Disconnect brake master cylinder push rod clevis
remove the clip and push rod clevis pin and wave washer, and
disconnect the push rod clevis from
the brake pedal.
3. Remove brake pedal support sub–assy
Remove the bolt from the bra ...