Toyota Corolla (E120): Circuit description

The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0117/45 is recorded when a ground short is detected in the side squib (lh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...

    Shifting the shift lever to R
    Shift the shift lever to R while lifting up the ring section. ■Maximum allowable speeds Observe the following maximum allowable speeds in each gear when maximum acceleration is necessary. mph (km/h) NOTICE ■To prevent damage to the transmission ●Do not lift up the ring ...

    Bluetooth® audio/phone
    The following can be performed using Bluetooth® wireless communication: ■ Bluetooth® audio The Bluetooth® audio system enables you to enjoy music played on a portable player from the vehicle speakers via wireless communication. This audio system supports Bluetooth®, a wireless data sy ...