Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Sfi system / Stop light switch circuit / Circuit description
Toyota Corolla (E120): Circuit description
This signal is used to detect that the brakes have been applied. The stp signal voltage is the same as the one supplied to the stop lights.
The stp signal is used mainly to control the fuel cut–off engine speed (the fuel cut–off engine speed is reduced slightly when the vehicle is braking.).
Wiring diagram
Other materials:
Rear wheel alignment
Inspection
1. Inspect tire
2. Measure vehicle height
Notice:
before inspecting the wheel alignment, adjust the vehicle height to the
specified value.
3. Inspect toe–in
Toe–in:
usa, canada:
Mexico:
If the toe–in is not within the specified value, inspect and replace
the susp ...
Preparations to use wireless communication
The following can be performed using Bluetooth® wireless communication:
■ A portable audio player can be operated and listened to via multimedia system
■ Hands-free phone calls can be made via a cellular phone In order to use wireless
communication, register and connect a Bluetooth ...
Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument
panel passenger airbag assy)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the airbag sensor
assy center and the instrument panel ...