Toyota Corolla (E120): Window defogger system

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

Overhaul
1. Remove cylinder block water drain cock sub–assy Remove the cylinder block water drain cock from the cylinder block. 2. Inspect connecting rod thrust clearance Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth. Standard t ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...