Toyota Corolla (E210): Multi-information display (4.2-inch display)

Share this page:

Other materials:

Malfunction in water temperature receiver gauge
Wiring diagram Inspection procedure 1 Read value of hand–held tester Check output value of ecm.  Connect the hand–held tester to dlc3.  Turn the ignition switch to on and push the hand–held tester main switch on.  Select the data list mode on the hand–he ...

Speedometer sensor (atm)
Replacement 1. Remove air cleaner case 2. Remove air cleaner hose no.1 3. Remove speedometer sensor  disconnect the connector.  remove the bolt and speedometer sensor assembly.  remove the clip and driven gear from the speedometer sensor. 4. Install speedometer sensor ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...