Toyota Corolla (E120): Short in side squib (lh) circuit

Dtc b0115/47 short in side squib (lh) circuit

Share this page:

Other materials:

Fail–safe chart
If any of the following codes is recorded, the ecm enters the fail–safe mode. Check for intermittent problems Hand–held tester only: by putting the vehicle’s ecm in the check mode, the 1 trip detection logic is possible instead of the 2 trip detection logic, and the sensitivity to de ...

Terminals of ecu
Oscilloscope wave (*1) Hint: terminal: od – gnd gauge set: 5 v / div, 50 ms / div condition: during cruise control driving o/d switch on. ...

Initialization
1. Reset memory Caution: perform the reset memory (at initialization) when replacing the automatic transaxle assy, engine assy or ecm. Notice: hand–held tester only Turn the ignition switch off.  connect the hand–held tester to the dlc3.  turn the ignition switch to th ...