Toyota Corolla (E120): Short in p/t squib (lh) circuit (to ground)

Dtc b0137/71 short in p/t squib (lh) circuit (to ground)

Share this page:

Other materials:

Inspection procedure
1 Check relay (marking: starter cut) Inspect the relay continuity, as shown in the illustration and table. Standard: 2 Check tvip ecu Disconnect the tvip ecu connector.  turn the ignition switch position to the start.  measure the voltage between the termina ...

Operating instructions
Turning the end of the lever turns on the lights as follows: ► Type A 1 The daytime running lights turn on. 2 The side marker, parking, tail, license plate, daytime running lights and instrument panel lights turn on. 3 The headlights and all the lights listed above (except daytime ...

Overhaul
1. Remove repair service starter kit Remove the nut, then disconnect the lead wire from terminal c. Remove the 2 screws which are used to secure the repair service starter kit to the starter drive housing.  remove the repair service starter kit.  remove the return ...