Toyota Tacoma manuals

BMW 5 Series 2016-2022 Owners Manual: Selector lever positions

Drive mode D

Selector lever position for normal vehicle operation.

All gears for forward travel are activated automatically.

R is reverse

Engage selector lever position R only when the vehicle is stationary.

Neutral N

The vehicle may be pushed or roll without power, for instance in vehicle washes in selector lever position N.

Parking position P

Selector lever position, for instance for parking the vehicle. The transmission blocks the drive wheels in selector lever position P.

Engage selector lever position P only when the vehicle is stationary.

Selector lever position P is engaged automatically in situations such as the following:

Engaging selector lever positions

General information

To prevent the vehicle from creeping after you select a drive mode, maintain pressure on the brake pedal until you are ready to start.

Functional requirements

Only when the drive-ready state is switched on and the brake pedal is depressed is it possible to change from selector lever position P to another selector lever position.

The selection lever position P cannot be changed until all technical requirements are met.

Engaging selector lever position D, N, R

A selector lever lock prevents the following faulty operation:

1. Fasten driver's safety belt.

2. Press and hold the button to release the selector lever lock.

3. Push the selector lever in the desired direction,

3. Push the selector lever in the desired direction, past a resistance point, if needed. The selector lever automatically returns to the center position when released.

Engaging selector lever position P

Engaging selector lever position P

Press button P.

Press button P.

Steptronic transmission
Concept The Steptronic transmission combines the functions of an automatic transmission with the possibility of manual shifting, if needed. Safety information Warning An unsecured vehicle can begin to ...

Rolling or pushing the vehicle
General information In some situations, the vehicle is to roll without its own power for a short distance, for instance in a vehicle wash, or be pushed. Engaging selector lever position N 1. Switch on ...

Other materials:

Onvehicle inspection
1. Inspect speedometer  check the operation. Using a speedometer tester, inspect the speedometer fro allowable indication error and check the operation of the odometer. Reference: Notice: tire wear and tire over or under inflation will increase the indication error. ...

Overhaul
Hint: overhaul the rh side by the same procedure as the lh side. 1. Remove front wheel 2. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 3. Remove front disc brake cylinder subassy Remove the union bolt and gasket fr ...

Replacement
1. Remove console box subassy rear 2. Remove parking brake lever subassy 3. Remove exhaust pipe assy front 4. Remove front floor heat insulator no.1 Remove the 3 nuts and front floor insulator no.1. 5. Remove front floor heat insulator no.2 Remove the 2 nuts and front floo ...

2011-2022 Copyright www.tcorolla.net