Toyota Corolla (E210): Changing engine switch modes

Modes can be changed by pressing the engine switch with brake pedal released. (The mode changes each time the switch is pressed.)

  1. OFF*1
    The emergency flashers can be used.
  2. ACC*2
    Some electrical components such as the audio system can be used.

    "ACCESSORY" will be displayed on the multi-information display.

  3. ON
    All electrical components can be used.

    "IGNITION ON" will be displayed on the multi-information display.

*1:If the shift lever is in a position other than P or the shift release button is pressed when turning off the engine, the engine switch will be remained to ON, not to off.

*2:ACC mode can be enabled/disabled on the customize menu.

■Auto power off function

If the vehicle is left in ACC or ON (the engine is not running) for more than 20 minutes with the shift lever is in P or the shift release button is not pressed, the engine switch will automatically turn to OFF.

However, this function cannot entirely prevent battery discharge.

Do not leave the vehicle with the engine switch in ACC or ON for long periods of time when the engine is not running.

■When ACC customization is in off

With the engine switch is turned off, the multimedia system can still be used for a certain time until the battery saving function starts operating.

NOTICE

■To prevent battery discharge

  • Do not leave the engine switch in ACC or ON for long periods of time without the engine running.
  • If "ACCESSORY" or "IGNITION ON" is displayed on the multi-information display, the engine switch is not off. Exit the vehicle after turning the engine switch off.

When stopping the engine with the shift lever in a position other than P

If the engine is stopped when the shift lever is in a position other than P or the shift release button is pressed, the engine switch will not be turned off. Perform the following procedure to turn the switch off:

1. Check that the parking brake is set.

2. Shift the shift lever to P.

Do not press the shift release button after shifting the shift lever to P.

3. Check that "IGNITION ON" is displayed on the multi-information display and press the engine switch shortly and firmly.

4. Check that "ACCESSORY" or "IGNITION ON" on the multi-information display are off.

NOTICE

■To prevent battery discharge

Do not stop the engine with the shift lever in a position other P or the shift release button pressed. If the engine is stopped with the shift lever in a position other than P or the shift release button pressed, the engine switch will not be turned off and remained to ON.

If the vehicle is left in ON, battery discharge may occur.

    Share this page:

    Other materials:

    Monitor description
    The battery supplies electricity to the ecm even when the ignition switch is off. This electricity allows the ecm store data such as dtc history, freeze frame data, fuel trim values, and other data. If the battery voltage falls below a minimum level, the ecm will conclude that there is a fault ...

    Replacement
    1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove front wheel rh 3. Remove front fender liner rh 4. Remove brake actuator with bracket  turn the latch of the actuator connector to disconnect the connector. ...

    Engine immobilizer system
    The vehicle’s keys have built-in transponder chips that prevent the engine from starting if a key has not been previously registered in the vehicle’s on-board computer. Never leave the keys inside the vehicle when you leave the vehicle. Vehicles without a smart key system: The indicator li ...