Toyota Corolla (E120): Seat belt buckle switch (lh) malfunction

Dtc b0126/27 seat belt buckle switch (lh) malfunction

Dtc b0127/27 seat belt buckle switch (lh) malfunction

Share this page:

Other materials:

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

On–vehicle inspection
1. Inspect turn signal flasher relay circuit Disconnect the connector from the turn signal flasher relay and inspect the connector on wire harness side as shown in the chart. Standard: Connect the connector to the turn signal flasher and inspect the wire harness side connector ...

Air conditioning filter
The air conditioning filter must be changed regularly to maintain air conditioning efficiency. Removal method 1Turn the engine switch off. 2 Open the glove box. Slide off the damper. 3 Push in the glove box on the vehicle’s outer side to disconnect the claws. Then pull out the glove box ...