Toyota Corolla (E120) 2002–2008 Repair Manual / Seat / Rear seat assy (sedan with bench type)

Toyota Corolla (E120): Rear seat assy (sedan with bench type)

Share this page:

Other materials:

Evap monitor (vacuum pressure monitor)
Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

Replacement
Hint: components: 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Disconnect skid control sensor wire (w/ abs) 4. Remove rear axle hub & bearing assy lh Remove the 4 bolts and hub & bearing assy lh. 5. Install rear axle hub & bearing assy lh Install t ...

Inspection procedure
1 Prepare for inspection Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  remove the horn button assy .  disconnect the connector of the instrument panel passenger airbag assy .  disconnect the connector of the front sea ...