Toyota Corolla (E120): Problem symptoms table

Hint

: use the table below to help you find the cause of the problem. The numbers indicate the probability of the cause of the problem. Check each part in the order shown. If necessary, repair or replace these parts.

On–vehicle inspection

    Share this page:

    Other materials:

    Replacement
    1. Remove combination meter assembly 2. Disconnect brake master cylinder push rod clevis  remove the clip and push rod clevis pin and wave washer, and disconnect the push rod clevis from the brake pedal. 3. Remove brake pedal support sub–assy Remove the bolt from the bra ...

    The ambient temperature does not display
    Wiring diagram Inspection procedure 1 Inspect outer ambient temperature sensor Remove cooler (ambient temp. Sensor) thermistor.  measure resistance between terminals 1 and 2 of cooler (ambient temp. Sensor) thermistor connector at each temperature. Resistance: at 0 c (0 f) ...

    Transmission valve body assy (atm)
    Replacement 1. Remove engine under cover lh 2. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 3. Remove automatic transaxle oil pan sub–assy Remove the 18 ...