Toyota Corolla (E210): Power outlet
The power outlet can be used for 12 V accessories that run on less than 10 A.
Lift the lid while pulling up the knob and open the power outlet lid.
■The power outlet can be used when
The engine switch is in ACC or ON.
■When turning the engine switch off
Disconnect electrical devices with charging functions, such as mobile battery packs.
If such devices are left connected, the engine switch may not be turned off normally.
NOTICE
■To prevent the fuse from being blown
Do not use an accessory that uses more than 12 V 10 A.
■To avoid damaging the power outlet
Close the power outlet lid when the power outlet is not in use.
Foreign objects or liquids that enter the power outlet may cause a short circuit.
■To prevent the battery from being discharged
Do not use the power outlet longer than necessary when the engine is not running.
Other materials:
Overhaul
Hint: components:
1. Remove front wheel
2. Disconnect front stabilizer link assy lh
Remove the nut and disconnect the front stabilizer link
assy lh from the shock absorber assy front lh.
Hint:
if the ball joint turns together with the nut, use a hexagon (6 mm)
wrench to hold the st ...
Check mode procedure
1. Dtc check (check mode)
Hint:
hand–held tester only:
compared to the normal mode, the check mode has more sensing
ability to detect malfunctions. Furthermore, the same diagnostic
items which are detected in the normal mode can also be
detected in the check mode.
Procedure for check m ...
Overhaul
1. Remove bench type rear seat cushion assy
Disengage the 2 clamps, and then remove the seat cushion.
2. Remove separate type rear seat back assy
lean the seat back forward.
remove the 2 clips.
remove the 2 bolts and seat back lh.
employ the same manner describ ...