Toyota Corolla (E210): USB charging port (if equipped)

The USB charging port are used to supply 3.0 A of electricity at 5 V to external devices.

The USB charging port are for charging only. They are not designed for data transfer or other purposes.

Depending on the external device, it may not charge properly.

Refer to the manual included with the device before using a USB charging port.

■ Using the USB charging port

Front

Lift the lid while pulling up the knob.

Rear (if equipped)

Rear (if equipped)

■The USB charging port can be

■The USB charging port can be used when

The engine switch is in ACC or ON.

■Situations in which the USB charging port may not operate correctly

  • If a device which consumes more than 3.0 A at 5 V is connected
  • If a device designed to communicate with a personal computer, such as a USB memory device, is connected
  • If the connected external device is turned off (depending on device)
  • If the temperature inside the vehicle is high, such as after the vehicle has been parked in the sun

■About connected external device

Depending on the connected external device, charging may occasionally be suspended and then start again. This is not a malfunction.

NOTICE

■To prevent damage to the USB charging port

  • Do not insert foreign objects into the port.
  • Do not spill water or other liquids into the port.
  • Do not apply excessive force to or impact the USB charging port.
  • Do not disassemble or modify the USB charging port.

■To prevent damage to external devices

  • Do not leave external devices in the vehicle. The temperature inside the vehicle may become high, resulting in damage to an external device.
  • Do not push down on or apply unnecessary force to an external device or the cable of an external device while it is connected.

■To prevent battery discharge

Do not use the USB charging port for a long period of time with the engine stopped.

    Share this page:

    Other materials:

    Wiring diagram
    1 Inspect terminal voltage(pi) (a) turn Turn the ignition switch to on.  measure voltage between terminal 5 (pi) of cruise control ecu assy and body ground, when the cruise control main switch button is on and off. Ok: 2 Inspect combination meter assy 3 Check harn ...

    On–vehicle inspection
    1. Washer motor Operation check pour the water into the washer jar with the washer motor and the pump installed to the washer jar assy.  Connect the battery (+) to terminal 2 of the washer motor and the pump, the battery (–) to terminal 1 of the washer motor and the pump ...

    Key confinement prevention function does not work properly (unlock warning switch circuit)
    Circuit description The unlock warning switch turns on when the key is inserted in the ignition key cylinder and the door courtesy switch turns on when the driver’s door is opened, and the integration relay monitors both switches conditions. According to these switches conditions, the int ...