Toyota Corolla (E210): Gauges and meters (7-inch display)

Share this page:

Other materials:

Inspection procedure
1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...

Overhaul
1. Drain brake fluid Notice: wash the brake fluid off immediately if it comes into contact with any painted surface. 2. Remove air cleaner cap sub–assy 3. Remove brake master cylinder sub–assy  disconnect the brake fluid level switch connector from master cylinder reservoir sub ...

Inspection procedure
Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Hint: ”a/f control” is the active te ...