Toyota Corolla (E120): Open in side squib (lh) circuit

Dtc b0116/48 open in side squib (lh) circuit

Share this page:

Other materials:

Diagnostic trouble code chart
The inspection procedures are shown in the table below. This table allows efficient and accurate troubleshooting using the diagnostic trouble codes displayed in the diagnostic trouble code chart. Proceed with troubleshooting in accordance with the inspection procedures listed in the diagnost ...

Dtc check/clear
Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

Inspection
1. Inspect sliding roof limit switch Inspect the sliding roof limit switch continuity. Standard: If the continuity is not as specified, replace the switch. 2. Inspect sliding roof drive gear sub–assy Connect the positive (+) lead from the battery to terminal 2 and the ne ...