Toyota Corolla (E120): Circuit description

The side squib (lh) circuit consists of the airbag sensor assy center and front seat airbag assy (lh).

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b0116/48 is recorded when an open is detected in the side squib (lh) circuit.

Wiring diagram

Wiring diagram

    Share this page:

    Other materials:

    Evap monitor (vacuum pressure monitor)
    Notice: a cold soak must be performed prior to conducting the drive pattern to complete the internal pressure readiness monitor. Cold soak preconditions The monitor will not run unless: mil is off. Fuel level is approximately 1/2 to 3/4. Altitude is 7800 feet (2400 m) or less. ...

    If you think something is wrong
    If you notice any of the following symptoms, your vehicle probably needs adjustment or repair. Contact your Toyota dealer as soon as possible. Visible symptoms ● Fluid leaks under the vehicle. (Water dripping from the air conditioning after use is normal.) ● Flat-looking tires or u ...

    Circuit description
    Refer to dtc p0010 Dtc no. Dtc detection condition Trouble area P0011 Condition (a) or (b) continues after engine is warmed up and engine speed at 550 to 4,000 rpm (problem of the advanced ocv):  valve timing does not change from current valve tim ...