Toyota Corolla (E120): Open in p squib circuit

Dtc b0106/54 open in p squib circuit

Share this page:

Other materials:

How to proceed with troubleshooting
The hand–held tester can be used at step 3, 4, 6, 9. 1 Vehicle brought to workshop 2 Customer problem analysis 3 Connect the obd ii scan tool or hand–held tester to dlc3 4 Check and clear dtc and freeze frame data 5 Visual inspection 6 Setting the check mode diagnosis 7 Proble ...

Towing your vehicle with 4 wheels on the ground
To prevent damage to your vehicle, perform the following procedures before towing. 1 Shift the shift lever to N. 2 Turn the engine switch to the “ACC” position (without a smart key system) or ACCESSORY mode (with a smart key system). (, 166) Ensure that the audio system and other powered de ...

Oxygen / af sensor heater monitor
Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...