Toyota Corolla (E210): Turn signal lever

Operating instructions

  1. Right turn
  2. Lane change to the right (move the lever partway and release it)
    The right hand signals will flash 3 times.
  3. Lane change to the left (move the lever partway and release it)
    The left hand signals will flash 3 times.
  4. Left turn

■Turn signals can be operated when

The engine switch is in ON.

■If the indicator flashes faster than usual

Check that a light bulb in the front or rear turn signal lights has not burned out.

    Share this page:

    Other materials:

    Inspection procedure
    1 Check d squib circuit(airbag sensor assy center – horn button assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector between the airbag sensor assy center and the horn button assy.  for the black ...

    Noise occurs
    Inspection procedure 1 Check of speaker installation Check speaker installation condition.  Check that each speaker is securely installed. Standard: malfunction disappear. Hint: the radio is equipped with noise prevention system that does not work against the regular use of t ...

    Rear wheel alignment
    Inspection 1. Inspect tire 2. Measure vehicle height Notice: before inspecting the wheel alignment, adjust the vehicle height to the specified value. 3. Inspect toe–in Toe–in: usa, canada: Mexico: If the toe–in is not within the specified value, inspect and replace the susp ...