Toyota Corolla (E210): Toyota Safety Sense 3.0 software update

It is necessary to enter a connected services contract, provided by Toyota, to use these functions. For details, contact your Toyota dealer.

WARNING

■For safe use

When the Toyota Safety Sense 3.0 software is updated, the operating methods of functions may change. Using this system without knowing the correct operating methods may lead to an accident resulting in death or serious injury.

  • Make sure to read the Digital Owner's Manual which corresponds to the software version of the system, available at the Owner's Manual website, before using this system.

Content of the Toyota Safety Sense Owner's Manual

This Owner's Manual contains information for Ver. 1 For the latest information about the controls, use, warnings/precautions, etc. of each function of Toyota Safety Sense, refer to the Digital Owner's Manual at the Owner's Manual website.

If the software of this system has been updated after initial purchase of the vehicle, before using this system, be sure to read the Owner's Manual which corresponds to the software version of the system.

■Precautions for use

  • Be aware that some functions may temporarily be disabled if a legal or safety related issue occurs.
  • If a connected services contract has not been entered or has expired, software updates will not be able to be performed wirelessly.

Updating the software

If a software update is available, a notification will be displayed by Toyota app. Follow the instructions displayed on the screen.

■Software update precautions

  • After a software update has been performed, it will not be possible to revert to a previous version.
  • Depending on the communication environment and the content of an update, a software update may take several hours. Although an update will be suspended when the engine switch is turned off, it will resume when the engine switch is changed back to ON mode.
  • Toyota Safety Sense can still be used while a software update is being performed.

■What can be checked using the Toyota app

The following items can be checked or performed.

  • Software version, update details, precautions, use methods, etc.
  • Software update
    Share this page:

    Other materials:

    Oxygen / af sensor heater monitor
    Preconditions The monitor will not run unless: mil is off  drive pattern  connect the obd ii scan tool to the dlc3 to check monitor status and preconditions.  Start the engine and allow it to idle for 9 minutes.  Drive the vehicle at 25 mph (40 km ...

    Inspection procedure
    1 Check low pitched horn assy Connect the positive (+) lead from the battery to the terminal and negative (–) lead to the horn body, and check that the horn blows. 2 Check relay (marking: horn) Remove the relay from the engine room j/b.  check the horn relay conti ...

    Circuit description
    When the idle switch is turned on, a signal is sent to the cruise control ecu assy. The cruise control ecu assy uses this signal to correct the discrepancy between the throttle valve position and the actuator position sensor values to enable accurate cruise control at the set speed. If the idl ...