Toyota Corolla (E120): Inspection
1. Inspect driver’s door lock
- Inspect the door lock motor operation.
Standard:
If the result is not as specified, replace the door lock assembly.
- Inspect the door lock and unlock switch continuity.
Standard:
If the result is not as specified, replace the door lock assembly.
- inspect the position switch continuity.
Standard:
If the result is not as specified, replace the door lock assembly.
2. Inspect passenger’s door lock
- Inspect the door lock motor operation.
Standard:
If the result is not as specified, replace the door lock assembly.
- Inspect the door lock and unlock switch continuity.
Standard:
If the result is not as specified, replace the door lock assembly.
- inspect the position switch continuity.
Standard:
If the result is not as specified, replace the door lock assembly.
3. Inspect rear door lock lh
- Inspect the door lock motor operation.
Standard:
If the result is not as specified, replace the door lock assembly
4. Inspect rear door lock rh
- Inspect the door lock motor operation.
Standard:
If the result is not as specified, replace the door lock assembly.
5. Inspect power window regulator master switch assy
- W/ power window: inspect the door lock control switch continuity.
Standard:
If the result is not as specified, replace the switch.
- W/o power window: inspect the door lock control switch continuity.
Standard:
If the result is not as specified, replace the switch.
6. Inspect door control switch assy
- Passenger’s side switch: inspect the door lock control switch continuity.
Standard:
If the result is not as specified, replace the switch.
Other materials:
If you think something is wrong
If you notice any of the following symptoms, your vehicle probably needs adjustment
or repair. Contact your Toyota dealer as soon as possible.
Visible symptoms
● Fluid leaks under the vehicle.
(Water dripping from the air conditioning after use is normal.)
● Flat-looking tires or u ...
Overhaul
1. Remove control shift lever bush
Remove the control shift lever bush from the selecting
bellcrank assy.
2. Remove selecting bellcrank dust cover no.1
Remove the selecting bellcrank dust cover no.1 From the
selecting bellcrank assy.
3. Remove selecting bell crank no.2
...
Inspection procedure
1 Check side squib(rh) circuit(airbag sensor assy center – front
seat airbag assy rh)
Disconnect the negative (–) terminal cable from the battery,
and wait at least for 90 seconds.
disconnect the connectors between the front seat airbag
assy (rh) and the airbag sensor assy center. ...