Toyota Corolla (E120): Power door lock control system

Share this page:

Other materials:

Replacement
1. Disconnect battery negative terminal 2. Remove engine under cover rh 3. Remove starter assy Disconnect the starter connector.  open the terminal cover. remove the nut, then disconnect the starter wire.  remove the 2 bolts, then remove the starter. 4. Install starter a ...

Side mudguard sub–assy lh
Replacement Hint: use the same procedures for the rh side and lh side. 1. Remove side mudguard sub–assy lh Using a clip remover, remove the 8 retainers and 9 clips.  using a moulding remover, remove the mudguard. 2. Install side mudguard sub–assy lh Install the mudgu ...

Inspection procedure
1 Inspect stop lamp switch assy Check that the stop light lights up when brake pedal is depressed and turns off when the brake pedal is released. 2 Inspect skid control ecu terminal voltage(stp terminal) Disconnect skid control ecu connector. measure voltage between termina ...