Toyota Corolla (E120): Front seat

Share this page:

Other materials:

Replacement
Hint: installation is in the reverse order of the removal. But the installation is indicated only when it has a point. 1. Remove spare wheel cover assy 2. Remove rear floor finish plate Remove the 3 clips.  using a moulding remover, remove the rear floor finish plate. 3. Rem ...

Circuit description
Refer to dtc p0120 Dtc no. Dtc detection condition Trouble area P0121 The following condition is met 4 times. After the vehicle speed has exceeded 19 mph (30 km/h) once, the throttle position sensor output value is out of normal range when the throttle ...

Inspection procedure
1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...