Toyota Corolla (E170): Deleting a Bluetooth® device

1 Display the “Bluetooth* Setup” screen. *: Bluetooth is a registered trademark of Bluetooth SIG, Inc.

2 Select “Remove”.

3 Select the desired device.

4 A confirmation message will be displayed, select “Yes” to delete the device.

5 Check that a confirmation screen is displayed when the operation is complete.

    Share this page:

    Other materials:

    Circuit description
    The d squib circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy. It causes the srs to deploy when the srs deployment conditions are satisfied. Dtc b0100/13 is recorded when a short is detected in the d squib circuit. Wiring diagram ...

    Positioning a floor jack
    When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. ◆ Front ◆ Rear 1 Take out ...

    Inspection
    1. Charcoal canister assy Visually check the charcoal canister for cracks or damage. Inspect the charcoal canister operation.  Plug the vent port with the cap.  While holding the purge port closed, blow air (1.76 Kpa, 18 gf/cm2, 0.26 Psi) into the evap port and ...