Toyota Corolla (E120): Cruise main indicator light circuit

Share this page:

Other materials:

On–vehicle inspection
1. Inspect front axle hub bearing  remove the front wheel.  separate the front disc brake caliper assy .  remove the front disc.  inspect the bearing backlash. Using a dial indicator, check the backlash near the center of the axle hub. Maximum: 0.05 Mm (0. ...

Inspection procedure
1 Check seat position air bag sensor Sst 09843–18040 Turn the ignition switch to on, and wait at least for 20 seconds.  clear the dtc stored in memory .  turn the ignition switch to lock, and wait at least for 20 seconds.  turn the ignition switch to on, and wait at ...

On–vehicle inspection
1. Inspect drive belt Visually check the belt for excessive wear, frayed cords, etc. If any defect is found, replace the drive belt. Hint: cracks on the rib side of a belt are considered acceptable. If the missing chunks from the ribs are found on the belt, it should be replaced. 2 ...