Toyota Corolla (E210): Vehicle specifications

Share this page:

Other materials:

Inspection procedure
1 Check p squib circuit(airbag sensor assy center – instrument panel passenger airbag assy) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the instrument panel ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...

Replacement
Hint: for parking brake cable assy no.2, Perform the same procedure to the parking brake cable assy no.3. 1. Remove rear wheel 2. Remove rear brake drum sub–assy 3. Remove rear brake automatic adjust lever lh 4. Remove front brake shoe  sst 09718–00010 5. Remove parking brake sho ...