Toyota Corolla (E210) 2019-2025 Owners Manual / For safety and security / Child safety / Using a top tether anchorage (for Puerto Rico)

Toyota Corolla (E210): Using a top tether anchorage (for Puerto Rico)

■ Top tether anchorages

Top tether anchorages are provided for each rear seat.

Use top tether anchorages when fixing the top strap.

  1. Top tether anchorages
  2. Top strap

■ Fixing the top strap to the top tether anchorages

Install the child restraint system in accordance to the operation manual enclosed with the child restraint system.

Rear outboard seats

pen the top tether anchorage cover, latch the hook onto the top tether anchorage and tighten the top strap.

Make sure the top strap is securely latched.

  1. Hook
  2. Top strap

Rear center seat

Latch the hook onto the top tether anchorage and tighten the top strap.

Make sure the top strap is securely latched.

  1. Hook
  2. Top strap

WARNING

■When installing a child restraint system

Observe the following precautions.

Failure to do so may result in death or serious injury.

  • Firmly attach the top strap and make sure that the belt is not twisted.
  • Do not attach the top strap to anything other than the top tether anchorages.
  • After securing a child restraint system, never adjust the seat.
  • Follow all installation instructions provided by the child restraint system manufacturer.

NOTICE

■Top tether anchorages

When not in use, make certain to close the lid. If it remains open, the lid may be damaged.

    Share this page:

    Other materials:

    On–vehicle inspection
    Notice: ”cold” and ”hot” in these sentences express the temperature of the coils themselves. ”Cold” is from –10 c (14 f) to 50 c (122 f) and ”hot” is from 50 c (122 f) to 100 c (212 f). 1. Inspect ignition coil (with igniter) and spark test  confirm dtc. Notice: ...

    Outer rear view mirror assy lh
    Replacement Hint: installation is according to the reverse order of the removal. In the rh side, work in the same procedure as in the lh side. 1. Remove front armrest assy lh 2. Remove power window regulator master switch assy (w/ power window) 3. Remove front armrest base panel upper ...

    Ecu power source circuit
    Circuit description This circuit provides power to operate the tvip ecu. Wiring diagram Inspection procedure 1 Check fuse (ecu–b) Remove the fuse from the instrument panel j/b.  check the continuity of the fuse. Standard: continuity 2 Check tvip ecu Disconnect ...