Toyota Corolla (E120): Circuit description

The d squib (2nd step) circuit consists of the airbag sensor assy center, spiral cable sub–assy and horn button assy.

It causes the srs to deploy when the srs deployment conditions are satisfied.

Dtc b1183/22 is recorded when a b+ short is detected in the d squib (2nd step) circuit.

 

Wiring diagram

    Share this page:

    Other materials:

    Overhaul
    Hint: components: 1. Remove rear wheel 2. Remove spare wheel cover assy 3. Remove rear floor finish plate 4. Remove luggage compartment trim cover inner lh 5. Remove rear shock absorber with coil spring Support the rear axle beam with jack. Remove the 2 nuts and bolt. ...

    Sliding roof/convertible
    Service data Torque specification Engine hood/door Torque specification Exterior/interior trim Torque specification Cruise control Service data Torque specification ...

    Inspection procedure
    Hint: this dtc chart is on the premise that the engine is cranked normally. If the engine is not cranked, proceed to the problem symptoms table on page 05–42. Read freeze frame data using the hand-held tester or the obd ii scan tool. Freeze frame data records the engine conditions ...