Toyota Corolla (E120): Circuit description

This solenoid goes on when signals are received from the ecu and controls the pressure acting on the wheel cylinders thus controlling the braking force.

Wiring diagram

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Removal & installation and disassembly & reassembly
    1. Remove oxygen sensor Remove a clip and tear off the floor mat.  disconnect a oxygen sensor connector. Remove the oxygen sensor. 2. Remove tail pipe assy Remove 2 bolts, 2 springs and tail pipe assy. 3. Remove floor panel brace front Remove 2 nuts and the ...

    On–vehicle inspection
    1. Inspect front axle hub bearing  remove the front wheel.  separate the front disc brake caliper assy .  remove the front disc.  inspect the bearing backlash. Using a dial indicator, check the backlash near the center of the axle hub. Maximum: 0.05 Mm (0. ...

    Precaution
    1. Precaution of headlight bulb replacement  if even a thin film of oil is left on the surface of the halogen lamp, its service life will be shortened because the lamp will be burn at a higher temperature.  handle any halogen lamp with great care. Dropping, hitting or damagin ...