Toyota Corolla (E120): Circuit description

This circuit sends a signal to the cruise control ecu assy that dtc output is required.

Wiring diagram

Inspection procedure

    Share this page:

    Other materials:

    Changing gears in the M position
    To enter 10-speed sport sequential shiftmatic mode, shift the shift lever to M position. Gear steps can then be selected by operating the shift lever or paddle shift switches, allowing you to drive in the gear step of your choosing. Upshifting Downshifting The gear changes once every time the ...

    Stabilizer bar rear
    Replacement Hint: components: 1. Remove stabilizer bar rear Remove the 2 bolts, nuts and stabilizer bar. 2. Install stabilizer bar rear Install the 2 bolts, nuts and stabilizer bar. Torque: 195 nvm (1,990 Kgf·cm, 144 ft·lbf) Hint: install the stabilizer bar so that the ...

    Inspection procedure
    1 Check p/t squib(rh) circuit(airbaga sensor assy center – front seat outer belt assy rh) Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connectors between the airbag sensor assy center and the seat belt pretensi ...