Toyota Corolla (E120): Brake system

Share this page:

Other materials:

Removal & installation and disassembly & reassembly
1. Remove bench type rear seat cushion assy 2. Remove rear floor service hole cover Remove the rear service hole cover. Disconnect the fuel pump and vapor pressure sensor connector. 3. Work for preventing gasoline from spilling out Start the engine.  after the engi ...

Operating instructions
Turning the end of the lever turns on the lights as follows: ► Type A 1 The daytime running lights turn on. 2 The side marker, parking, tail, license plate, daytime running lights and instrument panel lights turn on. 3 The headlights and all the lights listed above (except daytime ...

Inspection
1. Cooler thermistor no.1 Check resistance between terminals 1 and 2 of cooler thermistor no. 1 At each temperature, as shown in the chart. Resistance: If resistance value is not as specified, replace the sensor. 2. Cooler and accessory assy Inspect blower switch contin ...