Toyota Corolla (E140): Body dimensions

Share this page:

Other materials:

Terminals of ecu
1. Inspect integration relay Disconnect the connector from the integration relay. check the continuity between each terminal of the disconnected connector and the body ground, as shown in the illustration and table. Standard: If the result is not as specified, the vehicle’s ...

Inspection procedure
1 Inspect dlc3 terminal voltage(tc terminal) Turn the ignition switch to on.  measure voltage between terminals tc and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector betw ...

Heater & air conditioner
Preparation Sst Recomended tools Equipment Lubricant ...