Toyota Corolla (E120): Automatic transmission / transaxle

Service data

Torque specification

Torque specification

Manual transmission / transaxle

    Share this page:

    Other materials:

    Dtc check/clear
    Notice: if there is no dtc in the normal mode, check the pending fault code using the continuous test results function (mode 7 for sae j1979) on the obd ii scan tool or the hand–held tester. Hand–held tester only: when the diagnosis system is switched from the normal mode to the ...

    Circuit description
    The rear heated oxygen sensor is used to monitor oxygen concentration in the exhaust gas. For optimum catalytic converter operation, the air fuel mixture must be maintained near the ideal ”stoichiometric” ratio. The heated oxygen sensor output voltage changes suddenly in the vicinity of ...

    Inspection
    1. Inspect sliding roof limit switch Inspect the sliding roof limit switch continuity. Standard: If the continuity is not as specified, replace the switch. 2. Inspect sliding roof drive gear sub–assy Connect the positive (+) lead from the battery to terminal 2 and the ne ...