Toyota Corolla (E120): Brake

Service data

Torque specification

Torque specification

Parking brake

Parking brake

Service data

Torque specification

Torque specification

Automatic transmission / transaxle

    Share this page:

    Other materials:

    Front differential oil seal (atm)
    Replacement 1. Remove front wheels 2. Remove engine under cover rh 3. Remove engine under cover lh 4. Drain automatic transaxle fluid  remove the drain plug, gasket and drain atf.  install a new gasket and drain plug. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 5. Remove fron ...

    Adjustment
    1. Inspect and adjust clutch pedal sub–assy Turn over the floor carpet.  check that the pedal height is correct. Pedal height from asphalt sheet: 135.8 – 145.8 Mm (5.346 – 5.740 In.)  adjust the pedal height. Loosen the lock nut and turn the stopper bolt until ...

    Circuit description
    In the diagram below, when the engine is cranked, current flows from terminal st2 of the ignition switch to the starter relay coil and also current flows to terminal sta of the ecm (sta signal). When the sta signal and ne signal are input to the ecm, tr is turned on, current flows to the c ...