Toyota Corolla (E120): Sfr/Sfl/Srr/Srl solenoid circuit

Share this page:

Other materials:

Installing child restraints using a seat belt
■ Rear-facing - Infant seat/convertible seat 1 Place the child restraint system on the rear seat facing the rear of the vehicle. 2 Run the seat belt through the child restraint system and insert the plate into the buckle. Make sure that the belt is not twisted. 3 Fully extend the shou ...

Shifting the shift lever to R
Shift the shift lever to R while lifting up the ring section. ■Maximum allowable speeds Observe the following maximum allowable speeds in each gear when maximum acceleration is necessary. mph (km/h) NOTICE ■To prevent damage to the transmission ●Do not lift up the ring ...

Inspection procedure
1 Inspect dlc3 terminal voltage(ts terminal) Turn the ignition switch to on. measure voltage between terminals ts and cg of dlc3. Ok: voltage: 10 – 14 v 2 Check harness and connector(dlc3 – body ground) Check for open and short circuit in harness and connector between ...