Toyota Corolla (E120): Inspection procedure

1 Reconfirm dtc

  1. Check if the other dtcs are recorded

Replace brake actuator assy

Replace brake actuator assy

    Share this page:

    Other materials:

    Inspection procedure
    Hint: hand–held tester only: narrowing down the trouble area is possible by performing ”a/f control” active test (heated oxygen sensor or other trouble areas can be distinguished). Perform active test using hand–held tester (a/f control). Hint: ”a/f control” is the active te ...

    Canceling and resuming the constant speed control
    1 Pulling the lever toward you cancels the constant speed control. The speed setting is also canceled when the brakes are applied or the clutch pedal (manual transmission) is depressed. 2 Pushing the lever up resumes the constant speed control. Resuming is available when the vehicle speed is mo ...

    Inspection procedure
    1 Inspect skid control ecu connector(+bs terminal voltage) Disconnect the skid control ecu connector.  measure the voltage between terminals +bs (2) and gnd (1, 23) of skid control ecu harness side connector. Voltage: 10 – 14 v 2 Reconfirm dtc Check the dtc . Ok : ...