Toyota Corolla (E120) 2002–2008 Repair Manual / Diagnostics / Power door lock control system
Toyota Corolla (E120): Power door lock control system
Symptom |
Suspected area |
All doors are not operated by driver’s door key cylinder interlocked with key |
|
Key confinement prevention function does not work properly (unlock warning switch circuit) |
|
- How to proceed with troubleshooting
- Terminals of ecu
- All door lock and unlock do not operate by the master switch or the driver’s door key
- Key confinement prevention function does not work properly (unlock warning switch circuit)
Other materials:
Diagnosis system
Description
when troubleshooting obd ii vehicles, the only difference
from the usual troubleshooting procedure
is that you need to connect an obd ii scan tool complying
with sae j1987 or a hand–held tester to the
vehicle, and read off various data output from the
vehicle†...
Fuel system
Precaution
1. Before working on fuel system, disconnect negative (–) terminal cable
from
battery
2. Do not smoke or work near an open flame when working on fuel system
3. Keep gasoline away from rubber or leather parts
4. Work for prevent gasoline from spilling out
Remove the rear s ...
Inspection procedure
1 Inspect stop lamp switch assy
2 Check harness and connector(stop lamp switch assy – ecm)
Install the stop lamp switch assy.
disconnect the ecm connector.
measure the voltage according to the value(s) in the table
below when the brake pedal is depressed and rele ...