Toyota Corolla (E120): Front airbag sensor (lh) malfunction

Inspection procedure

Circuit description

Other materials:

Terminals of ecu
1. Inspect tvip ecu Inspect the ecu–b, dome and ecu–ig fuses. disconnect the tvip ecu connector, and the continuity and voltage of check each terminal of the disconnected connector. Standard: If the result is not as specified, the vehicle’s side may malfunction. Reco ...

Overhaul
1. Remove repair service starter kit Remove the nut, then disconnect the lead wire from terminal c. Remove the 2 screws which are used to secure the repair service starter kit to the starter drive housing.  remove the repair service starter kit.  remove the return ...

Check short circuit
If the wire harness is ground shorted as shown in fig. 5, Locate the section by conducting a resistance check with the body ground in step (b). Check the resistance with the body ground.  Disconnect connectors a and c and measure the resistance between terminals 1 and 2 ...