Toyota Corolla (E120): Precaution

1. Precaution of headlight bulb replacement

  1.  if even a thin film of oil is left on the surface of the halogen lamp, its service life will be shortened because the lamp will be burn at a higher temperature.
  2.  handle any halogen lamp with great care. Dropping, hitting or damaging the bulb, in any way, may result in it exploding and scattering because the internal pressure is high.
  3.  always prepare a new bulb for immediate replacement. While replacing the bulb, the lens may attract dust and moisture if removed from the vehicle for too long.
  4.  always use a bulb of the same wattage for replacement.
  5.  firmly reinstall the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through the gaps around the socket.
    Share this page:

    Other materials:

    Inspection procedure
    1 Check voltage at ig2 of airbag sensor assy center Disconnect the negative (–) terminal cable from the battery, and wait at least for 90 seconds.  disconnect the connector of the airbag sensor assy center.  connect the negative (–) terminal cable to the battery, and wa ...

    Noise occurs
    Inspection procedure 1 Check of speaker installation Check speaker installation condition.  Check that each speaker is securely installed. Standard: malfunction disappear. Hint: the radio is equipped with noise prevention system that does not work against the regular use of t ...

    Inspection procedure
    Hint: if dtcs p0115, p0116, p0117, p0118 and p0125 are output simultaneously, the engine coolant temperature sensor circuit may be open or short. Perform the troubleshooting of dtc p0115, p0117 or p0118 first. Read freeze frame data using the hand-held tester or the obd ii scan to ...