Toyota Corolla (E120): Sliding roof/convertible

Service data

Torque specification

Torque specification

Engine hood/door

Engine hood/door

Torque specification

Exterior/interior trim

Exterior/interior trim

Torque specification

Cruise control

Cruise control

Service data

Torque specification

Torque specification

Diagnostics

    Share this page:

    Other materials:

    Overhaul
    1. Remove generator pulley Sst 09820–63010 (09820–06010, 09820–06020) Hint: Hold sst 1 – a with a torque wrench, and tighten sst 1 – b clockwise to the specified torque. Torque: 39 nvm (398 Kgf·cm, 29 ft·lbf) Notice: check that sst is secured to the rotor shaft. ...

    Pressing power switch does not start system
    Wiring diagram Inspection procedure 1 Inspect radio receiver assy(+b, acc, gnd) Check that the continuity between terminals at each condition, as shown in the chart. Standard: Check that the voltage between terminals at each condition, as shown in the chart. Standard: ...

    Inspection procedure
    Hint: start the inspection from step 1 in case of using the hand–held tester and start from step 2 in case of not using hand–held tester. 1 Inspect brake actuator assy Select the datalist mode on the hand–held tester.  check the operation sound of the abs pump motor when operat ...