Toyota Corolla (E170): Other functions

■  Switching between outside air and recirculated air modes

Press The mode switches between outside air mode (indicator off) and recirculated air.

The mode switches between outside air mode (indicator off) and recirculated air mode (indicator on) each time ■ Defogging the windshield is pressed.

■ Defogging the windshield

Defoggers are used to defog the windshield and front side windows.

Set the air outlet selector dial to the Set the outside/recirculated air mode button to outside air mode if the recirculated position.

Set the outside/recirculated air mode button to outside air mode if the recirculated air mode is used. (It may switch automatically.) To defog the windshield and the side windows early, turn the air flow and temperature up.

Vehicles with the air conditioning system: If the dehumidification function is not operating, press to dehumidification function. operate the dehumidification function.

■ Defogging the rear window and outside rear view mirrors

► Vehicles without outside rear view mirror defoggers
Defoggers are used to defog the rear window.

Press The defoggers will automatically turn off after a period of time..

The defoggers will automatically turn off after a period of time.

► Vehicles with outside rear view mirror defoggers
Defoggers are used to defog the rear window, and to remove raindrops, dew and frost from the outside rear view mirrors.

Press The defoggers will automatically turn off after a period of time..

The defoggers will automatically turn off after a period of time.

    Share this page:

    Other materials:

    Brake Hold
    The brake hold system keeps the brake applied when the shift lever is in D, B (vehicles without paddle shift switches), M (vehicles with paddle shift switches) or N with the system on and the brake pedal has been depressed to stop the vehicle. The system releases the brake when the accelerator peda ...

    Things you should know
    ■ If you notice any symptoms If you notice any of the following symptoms, refer to the likely cause and the solution, and re-check. If the symptom is not resolved by the solution, have the vehicle inspected by your Toyota dealer. CAUTION ■When using the rear view monitor system ...

    Inspection procedure
    1 Inspect dlc3 terminal voltage Turn the ignition switch to on.  measure voltage between terminals 13 (tc) and 4 (cg) of dlc3. Ok: voltage: 10 – 16 v 2 Check harness and connector(between cruise control ecu assy and dlc3) Check for open and short circuit in harness ...